Top 10 common forklift crashes ， forklift operation must pay attention to these matters ！.

Don't undervalue the forklift at work. If the operation is bad, there will be significant accidents in minutes, and there are lots of mishaps involving forklifts.

Case 1: The forklift cargo blocked the chauffeur's view, and the individual ahead could not be located, causing a moving mishap.
Instance 2: In order to preserve the equilibrium of the forklift when lifting hefty products, the staff members utilized their body weight as the counterweight, which almost created casualties.
Situation 3: The size of the forklift cargo exceeds the allowable width of the course and hangs on the roadside rack, which nearly creates an crash.
Case 4: Forklift is speeding and rolls over during a turn.
Case 5: The forklift driver did not discover the pedestrian, and the pedestrian did not see the forklift.
Instance 6: The forklift lifts the employees unlawfully, the forklift vehicle driver does not put on the seat belt, the forklift lifter falls and the driver is crushed when the forklift surrender.
Case 7: The forklift motorist did not wear a seat belt and dropped from the car when it rolled over and was squashed.
Forklift procedure ought to take notice of these issues ：.

Begin.
1. Prior to beginning, observe the environments, and after validating that there are no obstacles that impede the safety of driving, honk the horn first and then begin.
2. For lorries with hydraulic ( atmospheric pressure) brakes, the brake hydraulic pressure ( atmospheric pressure) scale need to be safe prior to starting.
3. When the forklift begins with a lots, the driver ought to initially confirm that the tons is stable and trustworthy.
4. The start should be slow and stable.

Driving.
1. When driving, the height in between the bottom end of the fork and the ground should be kept at 300mm-400mm, and the pole should be slanted in reverse. .
2. Do not lift the fork expensive when driving. When getting in and leaving the job website or while driving, beware that there will certainly be no obstacles overhead. When the tons is traveling, the fork has to not be increased too high, which will impact the stability of the forklift. .
3. After dumping, the fork should be decreased to the normal driving placement prior to driving. .
4. When turning, if there are pedestrians or vehicles close by, the driving signal must be provided first. High-speed doglegs are banned. High-speed sharp turns will certainly cause the lorry to lose side security and tip over. .
5. When the forklift is downhill, it is strictly prohibited to turn off the flame and slide, and it is prohibited to brake instantly while driving with tons unless there are unique conditions.
6. When the forklift is running, it should obey the website traffic rules in the factory and have to keep a specific safety and security distance from the automobile in front. .
7. When the forklift is running, the load needs to remain in the most affordable placement that does not prevent the driving, and the gantry should be correctly tilted back. The load shall not be raised except when piling or filling. .
8. The elevation of the lots have to not obstruct the vehicle driver's view. In special scenarios, when the product impacts the forward vision, drive at a low speed when turning around.
9. It is restricted to switch on the ramp, nor to drive across the ramp. .
10. The safe driving rate of the forklift in the manufacturing facility area is 5 km/h, and it should drive safely at a reduced rate when going into the production workshop location. .
11. When the forklift is raised, lifted or driven, it is forbidden for employees to depend on the fork to hold products and play a balancing role. .
12. If troubles are discovered, they will be fixed and reported in a timely manner, and they will never run with health problems or conceal them.

loading and dumping.
1. When fork-loading products, the distance in between the two forks need to be changed as needed to make the lots of the two forks balanced and not manipulated, and one side Stand-on Electric Pallet Stacker of the item need to protest the rack. .
2. It is prohibited to work with a solitary fork or utilize a fork top or pull. In unique circumstances, safety and security warning signs have to be set up to advise surrounding pedestrians. .
3. In the process of filling and discharging items, the forklift needs to be braked with the brake. .
4. The rate of the vehicle must be slow and consistent. Be careful not to roll the wheels on the dunnage, so as not to extend the rolled objects and harm individuals. .
5. When using a fork to fork the goods, the fork needs to be as deep as possible under the tons, and it should be noted that the fork pointer ought to not touch various other goods or items. The lots should be supported with marginal back tilt of the gantry to ensure that the lots does not move in reverse. The mast can be tilted onward slightly when the tons is decreased to permit easy positioning of the lots and extraction of the forks. .
6. It is forbidden to fork products at broadband and collide with hard items with the fork head. .
7. When the forklift is functioning, it is restricted for people to stand around the fork, so as to prevent the collapse of the goods and injure individuals. .
8. Overloading is restricted, and it is forbidden to make use of forks to raise personnel to engage in high-altitude operations to prevent high-altitude dropping crashes. .
9. It is not permitted to make use of the brake inertia to slip, put, round or roll objects. .
10. It is not allowed to utilize forks to choose, turn pallet discharge.

Leaving .
1. It is prohibited to leave the forklift when the things on the fork impend. Prior to leaving the forklift, you have to dump the goods or reduced the fork structure.
2. Draw the hand brake handle to dead or dispirit the hand brake button.
3. The engine is switched off and the power is removed. (Except for unique conditions, such as the vehicle driver does not leave the lorry's view and does not go beyond 1 min).
4. Eliminate the secret. .

Forklift Operation Precautions.
1. Before and after the forklift operation, the appearance should be checked, and gas, lubing oil and air conditioning water ought to be added.
2. Check the safety efficiency of beginning, running and braking.
3. Check whether the lights and horn signals are complete and reliable.
4. Throughout the operation of the forklift, check whether the stress and temperature level are typical.
5. After the forklift is running, the external leak needs to likewise be inspected and the seals should be changed in time.

Forklift Safety Operation Specifications.
1. You need to inspect before leaving the car;.
2. When you run into somebody in front of you throughout driving, you must send a signal at a distance of 5 m;.
3. The driving rate in the factory does not exceed 5 km/h;.
4. When driving, the nadir of the cargo need to be 0.3 m ~ 0.4 m in the air;.
5. The turning need to not be as well sharp to prevent the propensity of " totally free switching";.
6. Running up and down the incline must be slow and consistent, and no turning on the incline is allowed.
7. Do not drive throughout the gradient. When the slope is greater than 10%, the lorry ought to be driven in reverse when declining;.
8. When the forklift employees bring the goods and move on, if they experience huge or heavy items and go to the motorist's line of sight, they must take the turning around exercise
.
The "Eight Prohibitions" need to be followed in the procedure.
1. Solitary fork operation is not permitted.
2. It is not allowed to lift the goods for cross country driving.
3. It is not allowed to get the goods by passing on the pallet with the fork.
4. It is not allowed to directly shovel chemicals, flammables and various other hazardous chemicals with forks.
5. It is not enabled to make use of inertia force to get the goods.
6. It is not enabled to make use of braking force to expatriation round or easy-to-roll things.
7. It is not allowed to bring people to service the pallet or fork, and it is purely forbidden to stand under the fork after Electric Forklift Truck for Warehouse the fork is raised.
8. Do not drive laterally on inclines
.
Car parking is not allowed under the list below problems.
1. Contours, narrow roads, railway crossings;.
2. Sections with a longitudinal incline more than 5%.
3. When there is an barrier on one side of the road, the opposite side of the section with the exact same length as the challenge must be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：[email protected]
Phone：+86 13827083844